Power Supply - Bosch UniversalInspect Originalbetriebsanleitung

20 | English
Digital inspection camera
Rated voltage
Non-rechargeable batteries (alkaline manganese)
Operating temperature
Storage temperature (without batteries)
Relative air humidity
Length of camera cable
Smallest bend radius of camera cable
Camera head diameter
Display resolution
Approx. operating time
Weight according to EPTA-Procedure 01:2014
(With batteries, without protective bag, without ac-
cessories)
Dimensions (length × width × height)
Protection rating of camera head and camera cable
Protection rating of housing
A) Free of condensation
For clear identification of your inspection camera, see the serial number (15) on the type plate.
Assembly

Power supply

The inspection camera can be operated with commercially available batteries.
To open the battery compartment cover (17), press on the locking mechanism (16) and
remove the battery compartment cover (17). Insert the batteries. When inserting the
batteries, ensure that the polarity is correct according to the illustration on the inside of
the battery compartment.
Always replace all the batteries at the same time. Only use batteries from the same man-
ufacturer and which have the same capacity.
Remove the batteries from the inspection camera when not using it for longer
u
periods. The batteries can corrode and self-discharge during prolonged storage.
Note: The ribbon (20) in the battery compartment is used to conveniently remove the
batteries.
1 609 92A 69V | (26.01.2021)
UniversalInspect
V=
4 × 1.5 V LR6 (AA)
°C –10 to +50
°C –20 to +70
% 5–95
mm 950
mm
mm
320 × 240
h
kg 0.39
mm 161 × 70 × 41
IP 67
Bosch Power Tools
6
A)
30
8
4
–