WOLFF WO 630 Design Cutter Originalbetriebsanleitung Seite 9

WOLFF GmbH & Co. KG | D-74360 Ilsfeld | Ungerhalde 1 | Tel. +49 (0)7062-91556-0 | Fax +49 (0)7062-91556-10 | E-Mail info@wolff-tools.com |
Changing the Nylon Bar
Use the provided Allan
wrench to remove the ten
screws, then hold the nylon
bar and carefully move it out
of nylon bar holder.
Warning: Do not put your
fingers against the sharp
edge of the blade at any time.
Transportation
Put the handle down towards
the working table, and then
move the pins on both sides of
the cam bar as shown to the
hole on the steel column to
keep the blade in a close
position, and then carry the
cutter as shown.
Internet www.wolff-tools.de
9