Mounting; Electrical Installation - Sick Gr18 Inox Betriebsanleitung

4
OPERATING AND STATUS INDICATORS
5

Mounting

6

Electrical installation

6
–
+
Figure 1: Operating element: Sensing range
Mount the sensor using a suitable mounting bracket (see the SICK range of acces‐
sories).
max. 90 Nm
Note the sensor's maximum permissible tightening torque of 90 Nm.
Note the preferred direction of the object relative to the sensor, cf.
The sensors must be connected in a voltage-free state (U
tion must be observed, depending on the connection type:
– Male connector connection: pin assignment
– Cable: wire color
Only apply voltage/switch on the voltage supply (U
tions have been established. The green LED indicator lights up on the sensor.
Explanations of the connection diagram (following tables):
Q / Q = switching outputs
n. c. = not connected
table 5.
= 0 V). The following informa‐
V
> 0 V) once all electrical connec‐
V
8021184.1ABM / 2020-12-21 | SICK
Subject to change without notice