Mettler Toledo IND310drive Installationsanleitung Seite 16

IND310drive Installation Manual
3. After releasing the front panel, lift the bottom of the front panel up and out until it
4. Raise the top of the front panel until it clears the two top clips. The cover will
The openings on the bottom of the enclosure are for serial I/O, ethernet, load cell, and
other peripheral component cables.
Once the IND310drive terminal is open, electrical connections can be made as shown
in Figure 2-2.
The IND310drive terminal is designed to withstand harsh environments. However,
care must be taken when installing cables and/or connectors that enter the terminal
enclosure. To ensure a water tight seal:
•
Use for Ethernet,
USB, PS/2
•
•
2-2
completely clears the enclosure.
swing down and is hinged by two wire cables at the bottom.
COM1
COM2
Pin 1
Figure 2-2: PCB with Associated Connectors
Pass the cables through an appropriately sized cable grip before connecting the
wires. For example, the ethernet cable goes through the large cable gland (see
Figure 2-3).
Figure 2-3: IND310drive Cable Glands
Insert the removable terminal strips or connectors in the appropriate sockets on
either the main board or on the scale card.
Ensure that the cable length from the terminal strip/connector to the terminal
housing is sufficient so that no strain is placed on the terminal strip or connector
assembly when the housing is in the fully open position.
Pin 1
Ethernet
USB
PS/2
Pin 1