Technical Specifications; Maintenance And Cleaning - THOMSON DS110B Bedienungsanleitung

TECHNICAL SPECIFICATIONS

• Remote control power source: CR2025 (batteries included)
• Power Requirements: Input: 100V~240V 50Hz/60Hz
• Power Consumption: 60W Max
• Audio Input Sensitivity: 114dB (AV IN), 114dB (LINE IN)
• Frequency ranges: FM: 87.5 to 108MHz
Note: Unit design and specifications are subject to change without notice. The manufacturer reserves the right to make the
necessary improvements.

MAINTENANCE AND CLEANING

Consult the following table if there is a problem with the appliance.
Problem
The sound of the radio is
distorted
No sound from the radio.
No sound in Bluetooth
mode
MAINTENANCE AND CLEANING
• Unplug the appliance before cleaning it.
• Remove fingerprints and dust with a soft and slightly damp cloth. Do not use abrasive products or solvents that may
damage the appliance's surface.
ATTENTION: Never immerse the appliance in water or in any liquid whatsoever.
• If it is not used for a long time, unplug the appliance and remove the batteries.
EN 12
Downloaded from www.Manualslib.com
Possible cause
• The station is not tuned in properly.
• The signal is weak in the area
• The unit is not in tuner mode.
• The volume is either muted or is at the
minimum level
• The Bluetooth peripheral is not
synchronised with the unit.
• The volume is either muted or is at the
minimum level.
is a trademark of TECHNICOLOR S.A. used under license by:
Parsons International France - 19 Boulevard Albert Einstein
77420 Champs sur Marne - France
N°Azur
French time: Monday to Thursday (from 9 am to 6 pm) and Friday (9 am to 3:30 pm)
www.thomsonaudiovideo.eu
manuals search engine
BLUETOOTH AUDIO RECEIVER
®
DS110B
• Set the station.
• Move the unit.
• Press SOURCE till the unit is in TUNER
mode.
• Adjust the volume level or press MUTE to
switch on the sound.
• Follow the instructions to synchronise the
Bluetooth device with the unit.
• Adjust the volume level or press MUTE to
switch on the sound.
(+33 ) 0825 745 770
call rate according to operator
Solution