Adjusting The Brakes - Rollz Motion2 Bedienungsanleitung

Adjusting the brakes

By using the Rollz Motion, the brakes can wear out. As a result, it may be
necessary to readjust the brakes. When the brakes are correctly adjusted, you
prevent problems and can make optimal use of them.Check the brakes regularly,
preferably before each use. When the Rollz Motion is on parking brake, the
wheels should not turn. When the hand brakes are released, the Rollz Motion
should not be slowed down.
If the brakes do not work properly, they can be adjusted in two ways: at the top
and bottom of the brake cable (Figure 56). The adjustment at the top of the
brake cable (just below the height adjustment handle) is for fine-tuning, so the
performance of the brake can be set a little tighter. The adjustment at the bottom
of the brake cable (near the rear wheels) is for a more radical adjustment. Make
sure that both the left and right brakes are properly adjusted.
Brake adjustment at the top of the brake cable
You can tighten the brakes using the brake adjustment at the top.
a. The Rollz Motion must not be on the parking brakes while adjusting the
brakes.
b. First loosen the locking ring (pull the cable down to make it easier). This
gives you the space to tighten or loosen the adjustment screw under it
(Figure 56).
c. Tighten the locking ring again and check if the brake provides the desired
braking force.
d. Do the same on the other side and check if both brakes offer the same
resistance.
Figure 56: Brake adjustment via the adjustment
screws at the top and bottom of the brake cable.
76
Figure 57: Brake adjustment via the adjust-
ment screw, just below the locking ring.