Herunterladen Inhalt Inhalt Diese Seite drucken

Important Notes On Safety And Operation; Labelling And Technical Data - Torqeedo 2218-00 Gebrauchsanweisung

Solar laderegler für power 48-5000
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1

1. Important notes on safety and operation

- Read these instructions carefully before installation and keep them handy
for future reference.
- Only use with Power 48-5000.
- Only compatible solar modules may be connected. These must be selected according
to the technical data provide in Chapter 2.
- If several solar modules are used (serial or parallel connection), the limits specified in
Chapter 2 must be observed for all the connected modules combined.
- Each solar panel may only be connected to one solar charge controller.
However, several solar panels may be connected to one solar charge controller.
- Do not short-circuit the solar system when it is connected to the charge controller.
- Do not measure the short-circuit current of the solar system when it is connected
to the charge controller. This will damage the charge controller.
1. Parallel connection
2. Series connection
16
3. Multiple controllers on the same module,
not allowed

2. Labelling and technical data

See the information plate on the underside of the product.
Technical data
Maximum module rated current (Imp)
Maximum module short-circuit current (Isc)
Minimum module voltage
Maximum module nominal voltage @ STC (Vmp)
Maximum module open-circuit voltage (Voc)
Maximum module power
Parallel connection
Charge cut-off voltage
Maximum efficiency
Operating point efficiency
Standby consumption
IP code
Solar module connection
Battery connection
Data connection
Dimensions
Weight
8 A
9 A
12 V
40.8 V
48 V
325 Wp
up to 6 charge controllers in parallel
49.5 V
99%
96 to 99%
< 1 mA
Charge controller (without fuse holder): Protected
from immersion IP67
Fuse holder: Protected from water spray IP64
– Cable not preassembled
– Colour coding: Yellow = plus, black = minus
– Cable length approx. 0.15 m
– Ring cable lug M8/red for positive pole, M10/black
for negative pole
– Cable length approx. 1.5 m
– TorqLink socket on the unit
– TorqLink T-cable included in scope of supply
– Cable length approx. 0.9 m
180 mm × 82 mm × 56 mm
720 g
DE
EN
FR
IT
ES
PT
DA
NL
SV
FI
17

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis