WOLFF T-REX Original Bedienungsanleitung Seite 49

4.3 Releasing and removing the removable container
Stop the vacuum motors by pressing the relevant STOP buttons.
Important!
Disconnect the plug from the power socket.
Wait at least five minutes to allow that the dust deposits at the bottom and then lift the lever
locates in the bottom part of the cleaner to release and remove the container.
Remove the container.
Empty the contents of the container into a special waste disposal container in accordance with laws
applicable in the country where the vacuum cleaner is used.
Caution!
While performing these operations, it is best to wear a dust protection mask.
To prevent having to use a dust protection mask and for greater convenience, before starting vacuuming
operations, it is best to fit a nylon bag inside the container and to fasten this in place with the special accessory
available on request.
Caution!
Perform the container release operation by means of the levers located on the sides or on the handle with
BOTH HANDS!
Danger of crushing upper limbs when fitting and locking the container on the vacuum cleaner.
Uzin Utz Tools GmbH & Co. KG | D-74360 Ilsfeld | Ungerhalde 1 | Tel. +49 (0)7062-91556-0 | Fax +49 (0)7062-91556-41 | E-Mail info@wolff-tools.com | Internet www.wolff-tools.com