Kirami Tubtainer 2 Gebrauchsanweisung Seite 51

© Kirami Oy, Finland
Problem
Water is not circulating / pump not
running
Device / Display not working
Device broken
Hose connections are leaking
High pressure in the filter
NOTICE! Normally the device returns to running mode in 4-5 minutes after the problem has been
fixed.
Tubtainer 2 heater/filter system
51/108
PROBLEMS
Reason
Power cord not plugged in
RCD keeps switching off.
Valve(s) closed
Hoses are glogged / bended
Device broken
Cartridge dirty / glogged
Display connection is bad
Fuse has burned
Power outage
Device broken
Loose connection, clamp not in its
place, missing sealing tape on
threads
O-ring fallen of or broken
Glogged / dirty filter
Pressure gauge broken
Table 2 – Problem situations
22.12.2020
Solution
Check connections and RCD
Open valve(s)
Check, clean unbend hoses.
Contact reseller
Clean or replace the cartridge
Open device and check display
connection
Check your load for the fuse and
replace / reset fuse
Wait for power to return, if freezing
temperatures empty and dry pool
and device to avoid freezing.
Contact reseller
Depending on the connection type,
check, tighten, reopen clean and
tighten.D o not overtighten plastic
threads.
Reset / replace o-ring
Clean / replace cartridgte.
Replace pressure gauge.
P 15/17
AGE