Operating Instructions Of Digital Control Unit - InfraWave RR-130 PENTAGON Bedienungsanweisung

EN

Operating Instructions of Digital Control Unit

When using the panel, the infrared heaters can be split into 4 zones: front heaters – dimmable,
back heaters – dimmable, leg heaters – dimmable and floor heating ON/OFF.
The user can adjust the power (intensity) of the heaters per zone individually.
General Safety Warning
This device is used as control unit for regulating the infrared heating elements and as light
switch in the infrared cabin. All required cables and temperature sensor are included. The control unit
has no panic button that switches off completely the power supply! The infrared heaters are switched
off in the Standby mode, but there can is still some low voltage!
Replacement or service of the infrared heating elements or cabin light can only be conducted
after the mains have been switched off.
Control panel keys:
Timer
This key starts or stops the infrared session. During a session his key is used to select the time
setting.
Front zone
Regulate the power of the Front Zone by means of the Up and Down keys.
Back Zone
Regulate the power of the Back Zone by means of the Up and Down keys.
Leg Zone
Switch the Leg Zone ON and OFF. The status of this output is indicated by the LED next to
the key.
Up and Down
Use the Up and down keys to adjust the power and the session time.
Floor Heating
Switch the Floor heating ON and OFF. The status of this output is indicated by the LED next
to the key.
Cabin light
Switches the cabin light ON and OFF.
30