Camera Reset - Instar IN-9008 Bedienungsanleitung

8. Camera Reset

In order to reset your camera, please follow the instructions below:
1. Loosen the four screws on the backplate of your camera and put it aside.
(See. Fig.1)
2. You will find a small black reset button next to the MicroSD slot inside the
camera. Keep pressing this reset button for 15-20 seconds. Once you release the
button, the camera will start the reset process. (See Fig. 2)
3. After the reset, the camera will restart, which can take up to 60 seconds. All
data in the camera will be reset to factory defaults. Therefore, please use a net-
work cable or WPS to reconnect the camera to your network. For more informa-
tion on how to install your camera again, please visit: http://install.instar.com.
Once you connect the camera to the network, use the INSTAR Camera Tool to
find out the camera's IP address and open the camera's WebUI to start configu-
rating your camera again.
Fig. 1
Fig. 2
Keep pressing for
15-20 seconds
12-EN
Go to http://install.instar.com