Troubleshooting - Napoleon ROGUE 525 Bedienungsanleitung

16

Troubleshooting

EN
Low heat / Low flame
when valve turned to
Excessive flare-ups/
Burners burn with
accompanied by the
Rear and Side burners
will not light with the
igniter, but will light
Main burner will not
light with the igniter,
but will light with a
Humming regulator.
Burners will not cross
www.napoleongrills.com
Problem
For propane - improper
high.
Improper preheating.
Sear plates installed
uneven heat.
Improper preheating.
Excessive grease and ash
build on sear plates and in
Possible spider web or other
yellow flame,
smell of gas.
Dead battery / or installed
with a match.
Loose electrode wire or
switch terminal wires.
Jet-fire outlet is dirty or
match.
Normal occurrence on hot
Dirty or corroded cross light
light each other.
Possible Causes
Ensure lighting procedure is followed
lighting procedure.
be in the off position when the tank
slowly to allow pressure to equalize.
Preheat grill with both main burners
incorrectly.
drip pan.
debris in burner. removing. See general maintenance
incorrectly.
Clean jet-fire outlet with a soft bristle
clogged.
days.
and does not affect the performance
brackets.
Solution
carefully. All gas grill valves must
valve is turned on. Turn tank on
See lighting instructions.
on high for 10 to 15 minutes.
See assembly instructions.
Preheat grill with main burners on
high for 10 to 15 minutes.
Clean sear plates and drip pan
regularly. Do not line pan with
aluminum foil. Refer to cleaning
instructions.
Thoroughly clean burner by
instructions.
Replace with heavy duty premium
battery.
Check that electrode wire is firmly
pushed onto the terminal on the
back of the igniter. Check that the
lead wires from the module to the
ignition switch (if equipped) are
firmly pushed onto their respective
terminals.
brush.
This is not a defect. It is caused by
internal vibrations in the regulator
or safety of the gas grill. Humming
regulators will not be replaced.
Clean or replace as required.
N415-0468CE-GB-DE AUG 17.18