Overheating Protection - Cloer 7561 Bedienungsanleitung

Dear Customer,
Thank you for choosing the Cloer coffee grinder.
From now on, you are able to enjoy coffee made
of freshly ground coffee beans.
We hope you enjoy your new coffee grinder.
Description
1 Cover
EN
2 Grinding knife
3 Number-of-cups controller (with ON/OFF
switch)
4 Coffee powder container with lid
5 Coffee bean container
6 Degree-of-grinding controller
7 Housing
8 Cable rewind
Setting up
·
Remove all packaging parts and, if applicable,
stickers, not the rating label.
·
Place the coffee grinder on a dry, non-slip and
even surface.
Before using the first time
·
Please read this instruction manual attentively
before using it for the first time.
·
Clean the device and its accessories with a moist
cloth. ATTENTION! Sharp edges!
·
Let the parts dry fully before use.
Safety notices for operation
·
The coffee grinder is exclusively intended
to grind coffee beans. Do not fill any other
foodstuffs (other beans, nuts etc.) into the
device.
·
Never operate the device without beans. Stop
grinding if the bean container has become
empty in the meantime by briefly pushing the
cup number controller.
·
The device must never be operated without the
grinding knife.
The appliance meets the
requirements of the applicable
EC directives.
The appliance is intended for
indoor use only.
·
Never leave the device unsupervised in
operation.
·
Never fill the container with coffee beans over
the rim.
·
Never immerse the coffee grinder in water or
other liquids!
ATTENTION! Always unplug
appliance when not in use and
before cleaning!
Instructions for assembly and use
·
Install the grinding knife (2) in the coffee bean
container (5):
8
(see page 2)
·
The symbol on the handle of the grinding
knife must point at the symbol „Lock open"
inside the device.
·
Now turn the grinding knife so that the symbol
points at the symbol „Lock closed"
the device is ready for operation.
·
To remove the grinding knife, turn it in the
opposite direction.
Important: While the coffee mill is
in use, the grinding knife always
must be installed correctly.
·
Please insert the coffee meal container (4)
correctly and always use the associated lid.
·
In the housing, there is a safety switch that
ensures that your coffee mill cannot be operated
when the coffee meal container (4) was not
inserted correctly.

Overheating protection

·
Please observe that the device should not run
for longer than 60 seconds and no more than 2x
in sequence to avoid overheating. There should
be at least 1 min between the two work steps.
·
During automatic grinding, the maximum
number of cups of the cup number controller
corresponds to 60 seconds.
·
If the device overheats anyway, the overheating
protection
will switch
automatically.
·
The device does not work for a while and is not
defective.
·
In this case, pull the plug from the socket and let
the device cool off for approx. 30 min.
·
Then the device is ready for operation again.
. Now
off the device