Technical Data; Installation - IKEA FRAMTID HGC6T Bedienungsanleitung

ENGLISH
Problem
The residual heat indica-
tor is not displaying any-
thing.
symbol plus a number
appears on the heat set-
ting display.
If there is a fault, first try to find a solution to
the problem yourself. If you cannot find a sol-
ution to the problem yourself, contact your
dealer or the After Sales Service.

Technical data

Rating Plate
Made in Germany
© Inter IKEA Systems B.V. 1999
801.597.41
PQM
The graphic above represents rating plate of
the appliance (without serial number which is
generated dynamically during the production
process), which is located at its underneath
surface of the casing.

Installation

Manufacturer is not responsible for any injury
to persons and pets or damage to property
caused by failure to comply following require-
ments.
Downloaded from www.Manualslib.com
Possible cause
The cooking zone was only on for
a short time and is therefore not
hot.
Electronics fault.
21552
manuals search engine
If the cooking zone is supposed
to be hot, call the After Sales
Service.
Disconnect the appliance from
the electrical supply for a few mi-
nutes (Take the fuse out of the
house's electric system) If after
switching on again,
played again, call the customer
service department.
If you operated the appliance wrongly, or
the installation was not carried out by a
registered engineer, the visit from the customer
service technician or dealer may not take
place free of charge, even during the warranty
period.
Model FRAMTID HGC6T Typ 55HAD47AO 7,0kW
PNC 949 593 124 S NO ...................... 220V-240V AC 50 Hz
Dear Customer, please apply here aside the
sticker you can find in the dedicate plastic bag
inserted inside the hob packaging. This will al-
low us to assist you better, by identifying pre-
cisely your hob, in case you will need in future
our assistance. Thank you for your help!
Caution! To proceed with the installation
refer to the assembly instructions.
9
Remedy
is dis-
230 V
DGT