Maintenance - Gmini trend Gebrauchsanweisung

Use only the raincoat which is part of the stroller equipment or which is supplied by the manufacturer
or distributor.
Prevent the contact of the stroller with sea/salt water; it causes corrosion!
Do not use the stroller on a beach!
If you do not use the stroller, keep it out of children's reach!
This product is not intended for commercial use.
Important note: Figures provided in these instructions are for illustrative purposes only and may differ from the
model which you bought.
RECOMMENDED CLEANING AND MAINTENANCE
Always store in a clean and dry place. This product requires regular maintenance. Cleaning and maintenance
must be performed only by an adult. Do not use the product if any part is missing, torn or damaged!
CLEANING
Plastic parts should be cleaned regularly by damp cloth. If the metal parts come into contact with water, dry them
to prevent corrosion. Do not use scouring powder or diluents. Ensure the fabric is dry before storing.
While cleaning the fabric follow the instructions on the product labels.
Below are symbols for washing and their meaning:
Removable fabric covers may be hand washed and non-removable fabric can be spot cleaned.
Use mild soap or upholstery shampoo. Wash separately. Do not bleach. Do not soak. Do not tumble dry.
Do not dry clean. Dry in shade thoroughly before reuse and avoid direct heat and sunlight.
Material: 100% Polyester

MAINTENANCE

If necessary, grease the moving parts with silicon oil.
Check the level of wear and tear of wheels regularly and remove dust and sand from them. Check plastic parts
which move on the stroller frame if they are not covered by dust or sand. You will reduce friction, which can
endanger the correct functionality of the stroller. Keep the stroller in a dry place.
If the metal parts come into contact with water, dry them to prevent corrosion. Long term exposure to sun beams
may cause bleaching of colours and fabrics.
GENERAL INSTRUCTIONS
UNFOLDING / FIG. 1
ATTENTION: Before performing this step you should always make sure that your child as well as other children
are a safe distance. Make sure that all the stroller's moving parts do not come into contact with child's body.
A. Folded stroller is secured with the safety against opening.
B. After opening release this safety, placed on the side of the stroller, unhook it from its position.
C. Grab the stroller by the handle and open the chassis pulling upward.
ATTENTION: Before use make sure that the stroller s fully opened and the back X support is locked in .
ASSEMBLY/RELEASE OF FRONT WHEELS / FIG. 2
To install the front wheels, insert the wheel's pin into the corresponding opening in the front axle When installed
properly you'll hear click. After releasing the wheel press the metal button on the back side of the mount and pull
the wheel out from its place. Repeat for second wheel as well
ATTENTION: Before you use the stroller, make sure that you have locked in the wheels properly. Pull them
lightly.
ASSEMBLY/RELEASE OF BACK WHEELS / FIG.3
Insert the back wheel's pin into the opening on the stroller's back axle. Insert the wheel into the axle until you hear
a click. To release the wheel just pull the metal lever downward and pull the wheel out.
ATTENTION: Before you use the stroller, make sure that you have locked in the wheels properly. Pull them
lightly.
IMPORTANT: Applicable only for the model GM1708 TREND Air / Inflate back wheel tires to a max. of 20-22
P.S.I., make sure that you do not exceed the value and overinflate the tire. Foe transport the wheels are to be
inflated only to 18-20 PSI.