General Instructions - Gmini trend Gebrauchsanweisung

GENERAL INSTRUCTIONS

Safety shoulder straps can be adjusted into two height levels. To change the height, pull the buckle through the
opening in the backrest and the backrest cover. Then insert it again into the opening at the required height and
pull the buckle from the other side of the backrest and secure the strap. The buckle is pulled easier if you turn it
vertically. Check that you secured the straps at the same height.
To check the proper installation of straps pull on them lightly.
For greater safety the stroller is equipped with "D" shaped rings and thus enables the connection of additional
safety strap according to the standard BS 6684. Rings are placed inside the stroller's seat on the right and left
side of the stroller.
Note If you'll be using a footmuff in the winter, then first pull the safety straps through the opening of the footmuff.
To adjust them follow the instructions stated above in this chapter.
STROLLER HANDLE ADJUSTMENT / FIG. 12
Stroller handle can be adjusted into two positions. Simultaneously press the side buttons on the handle and set
the handle into required position. Move the handle until it sets in the required position by itself. Click of the safety
will confirm its locking to you.
FOLDING THE STROLLER / FIG. 13
ATTENTION: Always make sure that your child or other children as well are at a safe distance. Make sure that all
the stroller's moving parts do not come into contact with child's body. Make also sure that the shopping bin us
empty
If the canopy is opened, fold it in the direction of the backrest. Put the backrest into the horizontal position. Lower
the leg rest. For easier manipulation during folding we recommend to release the front wheels.
A. Release the stud of the safety belt placed on the right side, under the seat.
B. Press the safety button to release, which is located on the right side of the chassis.
C. Grab the folding strap and pull it upward, until the stroller folds. Make sure that the stroller is
secured with the safety against sudden folding; the safety is located on the side of the stroller.
Note When storing do not use brute force, if the stroller is hard to fold, then check, whether there isn't anything
blocking the folding and repeat the step.
RAIN COVER
NOTICE: Be extra careful, if you have a rain coat on the stroller.
NOTICE: Rain coat cannot be used with a stroller without canopy as it causes a choking hazard to the child.
NOTICE: If you have a raincoat attached on the stroller never leave the stroller in the sun if your child is sitting in
it. Danger of heat stroke!
PUMP / FIG. 14-1, 2, 3, 4 / Note: Only for the model GM1708
The pump is stored in the stroller's bin.
If you need to inflate the stroller wheels, take out the pump from its storage in the bin.
1. Grab the pump by its head
2. Pull out the hose from the pump.
3. Screw the hose into the opening in the pump.
4. Unscrew the cap from the valve on the stroller wheel and screw on the pump's hose.
5. Inflate the wheel - / Back wheel tires should be inflated to max. of 20-22 P.S.I., make sure
that you do not exceed the value and over inflate the tire.
6. After inflation unscrew the hose and screw on the stroller valve cap