Automatic Shutoff; Sleep Mode; E) Timer; F) Air Filter Indicator - Conrad sygonix Bedienungsanleitung

c) Automatic shutoff
The air purifier uses a magnetic safety trigger to make sure that the filter cover is closed. The air purifier will automati-
cally turn off if the filter cover is removed.
d) Sleep mode
Sleep mode uses the lowest possible fan speed to operate quietly.
• Press to turn sleep mode on.
• Press or to exit sleep mode.

e) Timer

• Press repeatedly to turn the timer on or off, and to cycle through timer options (2 hours, 4 hours, 8 hours).
• The air purifier will automatically power off when the timer is finished.
• Press cancel the timer.

f) Air filter indicator

• will light up as a reminder to check if the air filter needs to be cleaned or replaced.
• See section "10. Care and cleaning" on page 26.

g) Reset the air filter indicator / lifetime

Reset filter lifetime
1
The filter lifetime should be reset if the
1. Connect the air purifier to the power supply and press
2. Press and hold
Hard filter lifetime
2
When using the air purifier in an environment of heavy pollution, the lifespan of the air filter may be significantly
reduced. You can change filters even if the filter light does not light up.
After replacing the filter, follow the steps below to perform a hard reset:
1. In standby mode, when the air purifier is plugged in but the power is off, press and hold
the lights up.
2. Press and hold
icon lights up after replacing the filter with a new one.
for 3 seconds until the
for 3 seconds again until the
to turn the power on.
light turns off.
light turns off.
for 3 seconds until
25