Automatic Charging - Samsung SR20H9050U Benutzerhandbuch

Steps to take if recharging is not being executed
Check the installation status of the
charger when:
▶charger is located in a place where vacuum
cleaning robot cannot easily access
▶distance of the charger and vacuum cleaning robot
is over 5 m apart
- It may take a long time for vacuum cleaning robot
to return to the charger for recharging
Downloaded from www.Manualslib.com

automatic charging

recharging
Low battery (Lo)
manuals search engine
When the battery indicator blinks
during cleaning, the vacuum
cleaning robot will return to
the charger to charge itself
automatically.
you may command the vacuum
cleaning robot to recharge at the
charger while it is in cleaning
process.
manually charge the vacuum
cleaning robot by placing it on the
charger.
manually charge the vacuum cleaning
robot when:
▶charger is located in a corner
▶battery is fully exhausted
▶vacuum cleaning robot is stuck by obstacles
(furniture etc.)
▶vacuum cleaning robot can't climb threshold near
charger (Height of the threshold that vacuum
cleaning robot can climb: about 1.5 cm and below)
▶when battery indicator blinks and "Lo" is displayed
▶when the vacuum cleaning robot is set on Spot
clean or Manual clean mode
ENGLISH-11