Notes And Cautions - Samsung SR20H9050U Benutzerhandbuch

notes and cautions

Charging
Note
▶ If the battery overheats during charging, it
may take longer to charge.
▶ When automatic charging is not working,
please check the followings.
– Turn the emergency switch (on the bottom of
the vacuum cleaning robot) off and on again.
– Unplug the charger's power plug and then plug
it back on.
– Check whether there is any foreign matter in the
charge pins clean the vacuum cleaning robot
and the charge pins of the charger with a dry
cloth or rag.
– Check for any obstacles such as reflective
objects, chairs, etc. near the charger.
▶ If the vacuum cleaning robot is left detached
from the charger, the battery will drain
naturally.
– Try to keep the vacuum cleaning robot
being charged on the charger. (Turn off the
emergency switch and leave the charger
unplugged when planning to leave the house
for long periods of time by going on a business
trip or vacation, etc., )
in use
Note
▶ The vacuum cleaning robot may get caught
on thresholds, etc. during cleaning.
– To restart operation, shut off the emergency
switch, move the vacuum cleaning robot to an
area where it can move easily and then turn on
the power again.
▶ The vacuum cleaning robot cannot
completely clean areas it cannot enter, such
as corners, between the wall and sofa, etc.
– Please use another cleaning tool to clean them
regularly.
Downloaded from www.Manualslib.com manuals search engine
▶ The vacuum cleaning robot cannot vacuum
clumps of dirt, so some may remain on the
floor after cleaning.
– Please use another cleaning tool to clean them
regularly.
▶ If the vacuum cleaning robot is turned off,
power cannot be turned on by the [Power]
button of the remote control. Press and
hold the [Start/Stop] button on the vacuum
cleaning robot.
▶ If the battery becomes low during Auto/Max
clean mode, the vacuum cleaning robot will
recharge and finish cleaning the remaining
area after recharging. (Repeat cleaning
frequency: 1 time)
▶ You cannot select and execute Max/Manual
clean mode while charging.
▶ Do not unnecessarily move the vacuum
cleaning robot or press buttons while it is
in Auto/Max clean mode. It assumes that
cleaning is complete and starts cleaning again
from the beginning.
Cleaning and maintenance
Note
▶ If you washed the dustbin and filter with water
– Dustbin: Completely wipe out the water.
– Filter: Completely dry it in a shade before use.
caution
▶ Watch your finger when attaching or
detaching the filter, since they may get stuck
in the dustbin's intake.
▶ To avoid blockages by foreign matter, do not
let toothpicks, cotton swabs etc. from being
vacuumed by the vacuum cleaning robot.
▶ If it is difficult to remove foreign matters from
the Power brush, contact a service center.
ENGLISH-22