Maintenance And Service - Bosch GPB Professional 18V-5 C Originalbetriebsanleitung

20 | English
To leave the menu function on any level and return to audio
operation, press the seek button (scan down) (13) for
longer than 1 second. Alternatively, the radio will automatic-
ally switch back to audio operation 10 seconds after the last
press of a button.
If menu settings are no longer being saved when you switch
off the radio, replace the back-up batteries.
Menu Options (GPB 18V‑5 SC)
The menu selection is partially dependent on the audio oper-
ating mode of the radio.
Within the menus, the name of each menu is displayed on
the top line of the multi-function indicator (k), and the se-
lectable setting on the bottom line.
<Set Time>
Time menu: You can choose between 12-hour <12 Hour
Mode> and 24-hour <24 Hour Mode> time formats, and ad-
just the time manually. If a radio station that transmits the
time is selected with the DAB audio source, this time is auto-
matically adopted.
<Reset All>
Reset menu: You can reset all menu settings to factory
settings <Yes> or return to the current settings <No>.
<Auto Scan> (with DAB audio source)
Automatic station search menu: You can start an auto-
matic station search.
<Manual Tune> (with DAB audio source)
Manual set-up menu: You can set the required frequency
manually.
<Display Type> (withDAB audio source)
Display mode menu: You can choose what text will appear
on the bottom line of the multi-function indicator (k):
– The information broadcast by the radio station <Dynamic
Label>,
– The frequency of the station <Frequency>,
– The signal strength <Signal Strength>,
– The program type broadcast by the radio
station <Program Type>.
<Display Type> (withFM audio source)
Display mode menu: You can choose what text will appear
on the bottom line of the multi-function indicator (k):
– The information broadcast by the radio station <Radio
Text>,
– The station name <Program Service>,
– The program type broadcast by the radio
station <Program Type>.
Power Supply of External Devices
USB Port
The USB port can be used to charge devices that can be
powered via USB (e.g. various mobile phones). The max-
imum charging current is 2,1 A.
Disengage the locking lever (8) and open the cover (7) of
the media compartment. Using a corresponding USB cable,
connect the USB port of the external device to the USB char-
ging socket (11) (USB) of the radio.
1 609 92A 5RG | (30.09.2020)
In operation with a rechargeable battery, the external device
will only be charged if the radio is switched on.
If it fits, you can place the external device in the storage
compartment (6) while charging. If the external device heats
up while charging, leave the cover (7) of the media compart-
ment open to protect the external device against overheat-
ing.
Once the charging process is complete or you have removed
the USB cable, close the cover (7) again to protect the radio
against dirt.
Alternating Current Connection
You can operate other external electrical devices using the
alternating current connections. Plug sockets can vary de-
pending on country-specific standards.
Power can only be supplied to external devices using the al-
ternating current connection when the radio is connected to
the mains; it is not possible using an inserted battery. If the
radio is connected to the mains supply, the green control
light (3) will light up to confirm this.
The total maximum permitted current consumption of all
connected electrical devices must not exceed the value
stated in the following table (also see the labelling on the
housing under the cover caps (4)):
Article number
3 601 DA4 000
3 601 DA4 100
3 601 DA4 170
3 601 DA4 1W0
3 601 DA4 130
3 601 DA4 140
Open the cover cap (4) of the alternating current connection
and insert the plug of the external electrical device into a
plug socket (5) on the radio.
Working Advice
Recommendations for Optimal Handling of the Battery
Protect the battery against moisture and water.
Only store the battery within a temperature range of −20 to
50 °C. Do not leave the battery in your car in the summer, for
example.
Occasionally clean the ventilation slots on the battery using a
soft brush that is clean and dry.
A significantly reduced operating time after charging indic-
ates that the battery has deteriorated and must be replaced.
Follow the instructions on correct disposal.

Maintenance and Service

Maintenance and Cleaning
Keep the radio clean to ensure good, safe operation.
In order to avoid safety hazards, if the power supply cord
needs to be replaced, this must be done by Bosch or by an
Total max. current con-
sumption (in A)
15
15
12
15
9
9
Bosch Power Tools