Operation; Cleaning And Care - Zoofari ZTSD 36 B1 Bedienungsanleitung

Operation

The fur to be cut must be dry and clean . Brush the
fur through to remove any knots .
1) Remove the blade guard 7 from the cutting
head 1 .
2) Place the required trimming guide ( 1 – 6 ) with
the prongs facing upwards on the cutting head 1
and thereby press the flap of the trimming guide
( 1 – 6 ) down firmly onto the lower metal edge
of the cutting head 1 (see illustration) .
■ Ensure that the trimming guide ( 1 – 6 ) has
properly engaged and is secured before starting
to cut/trim the fur .
NOTE
► It is advisable to first trim a small area so as to
test the individual comb attachments ( 1 – 6 ) .
Start with a comb attachment for long hair
(1/2" 4 or 3/8" 3 ) and, if necessary, use a
shorter one . The comb attachments ( 1 – 6 )
permit cutting lengths from 3 to 13 mm .
3) Switch the appliance on by sliding the On/Off
switch 3 to the position "ON" .
4) Slowly run the appliance through the fur against
the direction of hair growth . Hold the appliance
so that the trimming guide ( 1 – 6 ) is as flat as
possible against the animal .
–
In addition, with the adjustment switch 4 the
cutting length of the cutter head 1 can be
adjusted in steps(up to 2 mm) without having
to exchange the comb attachment ( 1 – 6 ) .
To do this, slide the adjustment switch 4
backwards to increase the cutting length in
steps . With this the cutting length of the
respectively attached comb attachment is also
increased by up to 2 mm .
■ 14 │ GB │ IE
Slide the adjustment switch 4 forward again
to reduce the cutting length or to bring the
comb attachment ( 1 – 6 ) back into its
original position .
–
Through removal of the individual trimming
guide ( 1 – 6 ), i .e . using only the cutting
head 1 itself, you can cut clean contours .
5) After use, switch the appliance off by sliding the
On/Off switch 3 to the position "OFF" .

Cleaning and Care

DANGER! ELECTRIC SHOCK
► Before cleaning, remove the plug from the
mains power socket .
CAUTION! PROPERTY DAMAGE!
► NEVER submerse the appliance in water or
other liquids .
■ Take the respective trimming guide ( 1 – 6 ), if
fitted, off .
■ Using exclusively the cleaning brush 8 , remove
the hairs from the cutting head 1 . Wipe off the
cutting head 1 with a damp cloth . After this,
dry the cutting head 1 off with a dry cloth .
We recommend that you occasionally clean the
cutting head 1 with medicinal alcohol .
■ If in regular use, the cutting head 1 should be
oiled occasionally . For this, use the supplied
blade oil 9 .
■ Remove excess oil with a dry cloth .
■ Clean the housing with a soft, dry lint-free cloth .
In cases of stubborn soiling, clean the housing
using a damp cloth and then dry it off with a dry
cloth .
■ Clean the trimming guides ( 1 – 6 ) in warm
water . Add a little mild detergent . Dry all parts
well before re-use .
■ S tore the appliance in a dry and dust free
location . When it is in storage, place the blade
guard 7 on the cutting head 1 .
ZTSD 36 B1