Operation; Cleaning And Care; Risk Of Electric Shock - Zoofari ZTSD 36 B1 Bedienungsanleitung

Operation

The fur to be cut must be dry and clean. Brush the
fur through to remove any knots.
.
head
Place the required trimming guide (1 - 6)
with the prongs facing upwards on the cutting
head and thereby press the flap of the trim-
ming guide down firmly onto the lower metal
edge of the cutting head (see illustration).
engaged and is secured before starting to cut/
trim the fur.
Note:
It is advisable to first trim a small area so as to test
the individual comb attachments. Start with a comb
attachment for long hair (1/2" 4 or 3/8" 3 )
and, if necessary, use a shorter one. The comb
attachments permit cutting lengths from 3 to 13 mm.
Switch the appliance on by sliding the On/Off
switch
the direction of hair growth. Hold the appliance
so that the trimming guide is as flat as possible
against the animal.
7 from the cutting
In addition, with the adjustment switch
cutting length of the cutter head
adjusted in steps(up to 2 mm) without having
to exchange the comb attachment. To do this,
slide the adjustment switch
increase the cutting length in steps. With this the
cutting length of the respectively attached comb
attachment is also increased by up to 2 mm.
Slide the adjustment switch
reduce the cutting length or to bring the comb
attachment back into its original position.
Through removal of the individual trimming
guide, i.e. using only the cutting head
you can cut clean contours.
After use, switch the appliance off by sliding the
On/Off switch

Cleaning and Care

Risk of electric shock!

Before cleaning, remove the plug from the mains
power socket.
liquids.
Using exclusively the cleaning brush 8, remove
the hairs from the cutting head
head may not be cleaned with water or
If in regular use, the cutting head
oiled occasionally. For this, use the supplied
blade oil 9 .
Store the appliance in a dry and dust free
location. When it is in storage, place the blade
guard 7 on the cutting head
- 3 -
can be
backwards to
forward again to
to the position „OFF".
. The cutting
should be
.
the
itself,