Disty distybox 300 Bedienungsanleitung Seite 30

10
2 Registration / programming
Function
Internal dialling tone
An internal dialling tone is sounded immediately on lifting the handset.
The dialling tone is suppressed using this setting. This setting is not
recommended if parameter 71 is set to 0.
With this setting the internal dialling tone is sounded as a continuous
tone (425 Hz). This setting is useful if your base station is connected
to a direct trunk line.
With this setting the internal dialling tone is sounded as an interrupted
tone (450 Hz). This setting is useful if your base station is connected
to a phone system that also generates an interrupted dialling tone.
Factory setting: 0
Volume setting
The handset volume can be adjusted here for the acoustics of your
connected device in increments of 3 dB (1 = minimum, 6 = maximum).
Factory setting: 5
Display of caller's number / CLIP 44
The caller's phone number is not transmitted to the connected
telephone. The ring cadence of calls is controlled by the base station.
Please note: function 51 is not available.
Display of caller's number/CLIP, fixed ring cadence.
Factory setting: 1
Field strength measurement
The current field strength is indicated on the handset by means of five
signals of differing pitch, the highest pitch indicating the best
reception. This ensures optimum set-up of the aerial for the base
station.
Parameter Other input
code
42 0 #
42 1 #
42 2 #
43 1...6 #
0 #
44 1 #
50 #