Raider RDI-AG47 Originalbetriebsanleitung Seite 15

4. Thoroughly respect to angle grinders.
4.1. Do not overload grinders. Use angle grinders only as intended. You will operate better
and safer when using the right angle grinder manufacturer in the specified range of load.
4.2. Do not use the angle grinder with a starting switch is damaged.
Angle grinder, which can not be excluded and included as intended by the manufacturer, is
dangerous and should be repaired.
4.3. Before you modify the settings of the angle grinder to replace work tools and additional
accessories as well as a long time when you will not use grinders, unplug the plug from the
supply network. This measure eliminates the danger of triggering the grinding inadvertently.
4.4. Keep grinding in places where they can be reached by children. Do not allow them to
be used by persons who are not familiar with how to work with them and have not read those
instructions. When you are in the hands of inexperienced users, grinders can be extremely
dangerous.
4.5. Keep grinding their care. Check whether the mobile units operate impeccable, whether
it spells, if there is a broken or damaged item which distort or alter the functions of the grinding
machine. Before using the angle grinder, make sure that the damaged parts to be repaired.
Many accidents are caused by poorly maintained power tools and appliances.
4.6. Use the angle grinder, attachment, working tools according to the manufacturer's
instructions. In doing so must comply with specific operating conditions and operations to
perform. Using grinders of various applications provided by the manufacturer increases the
risk of accidents.
5. Maintain.
5.1. Repairing your electric tools is best carried out only by qualified specialists in workshops
RAIDER, which used only original spare parts. Thus it ensuring their safe operation.
6. Guidelines for the safe handling, specific grinding purchased by you. General guidelines
for safe operation with a disc grinder and sandpaper, clean with wire brush and abrasive
cutting disk.
6.1. This grinding can be used for grinding with carboflex drive and sandpaper, clean
with wire brush, polishing and cutting carboflex disk. Follow all instructions and warnings
complying with technical parameters and the adjusted images. Failure to follow the following
instructions, the consequences may be an electric shock, fire and / or severe injuries.
6.2. This angle grinder is not suitable for polishing. Carrying out activities for which the
grinding is not intended, may be dangerous and cause injuries.
6.3. Do not use additional devices which are not recommended by the manufacturer for
this particular power. The fact that you can attach to specified device or machine working tool
does not ensure safe working with him.
6.4. Allowable speed of rotation of the working tools must be at least equal to the inscribed
plaque on the grinding speed of rotation. Working tools that rotate at a higher speed than the
maximum indicated on the angle grinder can break and pieces of them high speed.
6.5. The outer diameter and thickness of the working tools must comply with the particulars
specified in the technical characteristics of your angle grinder. Working tools with inappropriate
size may not be shielded as necessary or can be controlled well enough.
6.6. Grinding discs, flanges exposed discs or other tools must be applied precisely to fit
your shaft grinding machine. Working tools that do not fit exactly to the grinding spindle,
rotate unevenly vibrate heavily and can lead to loss of control over the machine.
6.7. Do not use damaged work tools. Before each use inspect the working tools, for
example abrasive discs for cracks or dislodge undergoing discs for cracks or wear strong,
wire brushes poorly secured or broken staples. If you miss grinding tool or work, check them
carefully for damage or use undamaged new work tools. Once you have checked carefully and
work tools are installed, allow grinding to work at maximum speed for one minute. Stay and
keep nearby people away from the plane of rotation. The most commonly damaged work tools
break during this test period.
6.8. Work with personal protective equipment. Depending on the application work with
all face mask, eye protection or goggles. If necessary, work with breathing mask, silencers
15