Gateway Address - Block WFR 700 Bedienungsanleitung

4. Gateway address

Set the Gateway address with „ " and „ " or with the „CONTROL" dial. Use the „ u " and „t "
buttons to switch between fields. Press „ENTER" to switch to the next field.
5. DNS
" and „ T " or with the „C ONTROL" dial.
Now set the primary and secondary DNS address with „S
" and „ t " buttons to switch between felds. Press „ENTER" to switch to the next feld.
Use the „ u
For beyond a network:
6. SSID
Set the wireless network identifcation. Use the navigation buttons or the „CONTROL" dial to
move the cursor through the displayed characters. Press either the „ENTER " button or the „CON-
TROL" dial to confrm the selected character.
› Select „BKSP " to delete the last character selected.
› Select „C ANCEL" t o cancel your input.
› Select „OK" to confrm the entered code and to try to establish a connection to the selected
network.
7. Authentication
Now set the preferred method of authentication.
Open, Pre-Shared Key (PSK), WPA (Wi-Fi Protected Access) or WPA2.
8. Encryption type
Now select the appropriate encryption type.
Disabled (of) or WEP (Wired Equivalent Privacy) for Open or PSK, TKIP (Temporal Key Integrity
Protocol) or AES (Advanced Encryption Standard).
9. Key
Now enter the code for the wireless network. Use the navigation buttons or the „CONTROL" dial
to move the cursor through the displayed characters. Press either the „ENTER" button or the
„CONTROL" dial to confrm the selected character.
› Select „BKSP " to delete the last character selected.
› Select „C ANCEL" t o cancel your input.
› Select „OK" to confrm the entered code and to try to establish a connection to the selected
network.
Now the device will try to establish a connection using the data previously entered.
Chapter 7
Internet radio 47
Downloaded from www.Manualslib.com manuals search engine