Possible Cause; Troubleshooting - blum SERVO-DRIVE Bedienungsanleitung

Problems
SERVO-DRIVE will not
work on any drawers when
pushing or pulling.
SERVO-DRIVE will not work for
an entire cabinet when pushing
or pulling.
SERVO-DRIVE will only
work when drawer is
pulled – not by pushing.
SERVO-DRIVE does not
work for an individual
pullout unit – neither pulling
nor pushing.
18

Possible cause

The Blum transformer is not
connected to the power outlet.
The power supply has been
interrupted.
Blum transformer is defective.
Cabling is defective.
Object is obstructing path.
Blum distance bumper was
removed or is defective.
Max. fill height of drawer has
been exceeded.
SERVO-DRIVE is defective.
BA-139
Remedy
➢ Plug in the Blum transformer
to the outlet.
➢ Check the circuit breaker/
fuse box.
➢ If necessary, contact an
authorised electrician.
➢ If necessary, have the
distributor's customer service
replace the Blum transformer.
➢ Contact your dealer's
customer
service to correct the
problem.
➢ Remove the obstruction.
➢ Contact your dealer's
customer service to replace
the Blum distance bumper.
➢ Open the drawer manually.
➢ Remove the items that are
too high from the pull-out unit.
➢ Contact your distributor's
customer service to replace
the drive unit.