ASROCK 970 Extreme3 Bedienungsanleitung Seite 18

Step 2.
Step 3.
2.5.2 Driver Installation and Setup
Step 1.
Step 2.
Step 3.
18
Downloaded from www.Manualslib.com
Connect two Radeon graphics cards by installing CrossFire Bridge on
CrossFire Bridge Interconnects on the top of Radeon graphics cards.
(CrossFire Bridge is provided with the graphics card you purchase, not
bundled with this motherboard. Please refer to your graphics card vendor
for details.)
CrossFire Bridge
Connect the DVI monitor cable to the DVI connector on the Radeon graph-
ics card on PCIE2 slot. (You may use the DVI to D-Sub adapter to convert
the DVI connector to D-Sub interface, and then connect the D-Sub monitor
cable to the DVI to D-Sub adapter.)
Power on your computer and boot into OS.
TM
Remove the AMD
tem.
The Catalyst Uninstaller is an optional download. We recommend using this
utility to uninstall any previously installed Catalyst drivers prior to installation.
Please check AMD website for AMD
Install the required drivers to your system.
®
For Windows XP OS:
TM
A. AMD recommends Windows
installed (If you have Windows
in your system, there is no need to download it again):
http://www.microsoft.com/windowsxp/sp2/default.mspx
B. You must have Microsoft .NET Framework installed prior to
downloading and installing the CATALYST Control Center. Please
check Microsoft website for details.
ASRock 970 Extreme3 Motherboard
manuals search engine
or
driver if you have any VGA driver installed in your sys-
TM driver updates.
®
XP Service Pack 2 or higher to be
®
XP Service Pack 2 or higher installed