Black & Decker MTJS1 Originalanleitung Seite 4

ENGLISH
Keep blades sharp. Dull or damaged blades
u
may cause the saw to swerve or stall under
pressure. Always use the appropriate type of
saw blade for the workpiece material and type
of cut.
When cutting pipe or conduit, make sure that
u
they are free from water, electrical wiring, etc.
Do not touch the workpiece or the blade
u
immediately after operating the tool. They can
become very hot.
Be aware of hidden hazards, before cutting into
u
walls, floors or ceilings, check for the location
of wiring and pipes.
The blade will continue to move after releasing
u
the switch. Always switch the tool off and
wait for the saw blade to come to a complete
@ standstill before putting the tool down.
Warning! Contact with, or inhalation
of dusts arising from cutting applica-
tions may endanger the health of the
operator and possible bystanders.
Wear a dust mask specifically
designed for protection against dust
and fumes and ensure that persons
within or entering the work area are
also protected.
4
Downloaded from www.Manualslib.com
(Original instructions)
manuals search engine
The intended use is described in this instruc-
u
tion manual. The use of any accessory or
attachment or performance of any operation
with this tool other than those recommended
in this instruction manual may present a risk of
personal injury and/or damage to property.
Features (fig. A)
Tool shown is MT143. Other tools are available for
use with this tool head.
This tool includes some or all of the following
features.
10. Jigsaw head
11. Blade clamp
12. Blade clamp lever
13. Shoe
Assembly
Warning! Before assembly, remove the battery
from the tool.
Fitting and removing a saw blade (fig. A)
Lock the tool by setting the forward/reverse
u
slider (2) to the centre position.
To fit a saw blade, press the blade clamp lever
u
(12) down (located at the rear of the jigsaw
head) and hold it in this position.