Leifheit Dry & Clean Bedienungsanleitung Seite 46

NOTE: The powered-on device operates quietly in stand-by mode. The window
cleaner generates its full power once the rubber lip of the window cleaner is placed
on the glass pane or is lightly pressed. The battery charge lasts longer due to this
automatic power control.
• After suction cleaning the window, power off the device by pressing the
appliance switch.
2. Interrupting work
• Place the device on its base (see figure 2) and power it off while it is not in use.
NOTE: If the window vacuum is not used for 2 minutes while it is switched on
(no contact between rubber lip and a hard surface), the device will switch into
sleep mode; the LED will flash in green. The vacuum function will be activated
automatically once the rubber lip comes into contact with a window pane.
To interrupt or stop work for a long period of time, always use the main power
switch to shut the device off.
3. Emptying the container during work
• If the maximum fill level (marked „MAX" see figure 6) of the dirty water tank has
been reached, the tank must be emptied. NOTE: If the maximum fill level is exceeded,
small amounts of water may leak out of the ventilation slots if the device is tilted too
far. In order to avoid this, empty the tank before the maximum fill level is exceeded.
• To do this, power off the device, open the side closure on the dirty water tank and
pour the water into a container or drain (see figure 7). Then close the tank again.
4. Ending work / cleaning the device
• Power off the device. Unlock the tank via the release button and remove
it (see figure 8).
NOTE: The device cannot be powered on when the tank is unlocked.
• Remove the bottom cap from the tank and empty it through the opening in
the base (see figure 9). Rinse the tank out with clean water (see figure 10).
• Do not put any hard objects, such as a washing-up brush, into the tank as
this may cause damage.
• Release the suction nozzle (see figure 11) and clean both nozzle and
rubber lip under flowing water.
• Leave the device to dry fully while in the open position. Charge the battery
after the work is complete.
• Lock the tank before the next use by pushing the tank cover until it connects
with the tank. Be careful to ensure that the tank cover is pushed into the
correct position (see figure 12).
• Push the tank onto the basic device from above until you hear the connection make
an audible click. Insert the tank into the housing at a slight angle. (see figure 13).
CAUTION: The basic unit contains electrical components.
Therefore, do not clean the basic unit under running water!
NOTES
1. Do not use the window cleaner on rough surfaces.
2. Clean the device with a damp cloth.
3. Never submerge the device in water.
4. If your product does not work properly under normal conditions,
please contact your dealer with your proof of purchase.
Figure 13:
Attaching the tank
46
GB
Figure 12:
Lock the tank cover
Figure 6:
Maximum fill level
Figure 7:
Emptying the tank
Figure 8:
Unlock the tank
Figure 9:
Remove the bottom cap
Figure 10:
Cleaning the tank
Figure 11:
Release suction nozzle