Before First Use; Assembling And Use - Klarstein 10028002 Bedienungsanleitung

Before using the appliance for the first time, clean these parts which may contact with food ingre-
dients thoroughly.

Before first Use

Control button operation instructions:
Button ON: For normal use
Button O: Close and stop
Button R: Reverse function
Use the reverse function when pulp discharge is blocked or the
motor is clocked (Press and hold „R" for about 3 seconds, the
juicing screw will begin to reverse. After „R" button is released,
the juicing screw will stop reversing. If press the „On" button
again at this time, the juicing screw will return to normal work).

Assembling and Use

Connect the juicing body and the main body:
Align the mark
lock triangular sign" on the main body and then put the
1
juicing body into the main body (the three clips on the
juicing body will realize alignment). Then turn the juicing
body anticlockwise. When there is a click, it means that the
connection is finished
Align the polygonal shaft of juicing screw with the polygo-
2
nal shaft hole of the motor mounted in the drive unit
Fit the larger-opening end of the juice strainer into the tail
of the juicing screw and push it while the three clips of
3 the juice strainer align with the three clamping slots in the
juicing body. (The juice strainer is used with the juicing
button hereinafter, this function is used for juicing.)
Push the juicing body cap into the juicing body horizontally
while the three clips on the juicing body cap are stagge-
4 red from the three clips on the juicing body. Then turn the
juicing body cap anticlockwise until the figures „1" and „2"
on it are on the right above positions.
on the juicing body with the mark „un-
10