Werbung
Jabs-flex imp pump data
PAGE 30 IMPELLER REMOVAL 1
Impeller Removal Tool
Impeller Removal Tool
• Simple to use • Fits ALL makes • Avoids damage to pump
• All Stainless Steel
Outil d'extraction de la turbine
• Facile à utiliser • Conçu pour TOUTES les marques • Evite
l'endommagement de la pompe • Fabrication intégrale en
acier inoxydable
Abziehwerkzeug für Impeller
• Leichte Handhabung • Für ALLE Fabrikate geeignet •
Verhindert Beschädigung am Pump-engehäuse • Aus
rostfreiem Stahl hergestellt
Estrattore per giranti
• Di facile uso • Adatto a TUTTE le marche • Evita danni alla
pompa • Tutto acciaio inossidabile
Waaier uitbouwgereedschap
• Eenvoudig in gebruik • Past op ALLE merken • Voorkomt
beschadiging van de pomp • Geheel uit RVS
Demonteringsverktyg för impellrar
• Enkelt att använda • Passar ALLA fabrikat
• Skadar inte pumpen • Helt i rostfritt stål
Herramienta para extraer Impulsores
• Fácil de utilizar • Apta para TODAS las marcas • Evita el
daño a la bomba • Totalmente de acero inoxidable
21/11/07
11:38 am
Page 7
✘
PAGE 3
GB 2
If in any doubt about the use of any Jabsco product in a
8.
potentially explosive atmosphere - consult the factory or our
website.
MOTORS CAN SPARK AND EXPLOSION AND DEATH CAN OCCUR.
DO NOT USE WHERE FLAMMABLE VAPOURS ARE PRESENT.
Make all electrical connections in dry locations. Connections in
9.
humid environments should be sealed to prevent corrosion.
Wiring must comply with applicable electrical standards and
include a correctly sized fuse or circuit breaker in the positive
(+) lead as close as possible to the power source.
INCORRECT WIRING COULD CAUSE A FIRE
RESULTING IN INJURY OR DEATH.
Ensure sufficient voltage (not less than 95% of rated voltage) is
10.
available at the pump when it is running.
AC powered pumps should be used in conjunction with an
11.
RCD circuit breaker.
Motor cases may get hot. Prolonged contact during operation
12.
may cause burns.
Exceeding recommended pump discharge pressure would
13.
shorten the impeller life.
Rubber impellers will give best life if following temperature
14.
guidelines followed. Neoprene 4° to 80°C (39° to 176°F),
Nitrile 10° to 90°C (50° to 194°F), Viton 15° to 90°C (60° to
194°F), EPDM 4° TO 100°C (39° TO 212°F)
Liquids must not be allowed to freeze in pump body, to
15.
winterise your system all water must be drained from the entire
system, including the pump.
DO NOT USE AUTOMOTIVE ANTI FREEZE IN DRINKING
WATER SYSTEMS – IT IS POISONOUS.
TO AVOID PUMP DAMAGE - DO NOT USE PETROLEUM
BASED ANTI-FREEZE COMPOUNDS OR RUST INHIBITORS.
No used pumps/parts will be accepted as returns unless
16.
complete details of liquids pumped are supplied.
Werbung
