Duct; External Cover; Fan; Mounting - Maico AKE 100 Montage- Und Betriebsanleitung

8.3 Duct

1. Debur edges on the inside of the duct.
2. Perform installation preparations as
described in Chapter 8.1.

8.4 External cover

1. Unpack the external shutter with external
climate sensor and remove outer piece
[11]. To release the outer piece's locking
hook, unlock ( arrow) using a
screwdriver.
Do not remove the sensor
connection cable from the external
climate sensor. It is connected to the
fan, through the duct, when the
housing is mounted.
Fit supplied sealing strip centred in socket.

8.5 Fan

1. Unpack unit and take off designer cover
[3]. To release the cover's locking hook,
unlock ( arrow) using a screwdriver.
2. Remove internal climate sensor [5].
8. Installation preparations │ UK
3. Remove the electronics cover [6]. Unlock
locking hook ( arrow) with screwdriver.
4. Fit supplied sealing strip centred in
socket..
The sealing strip must be fitted to
AKE100 so that the units do not draw
in any unwanted air from outside.

9. Mounting

When installing the FE 100/1 window
installation kit or the ECA-DR
spacing frame,  associated
mounting instructions.

9.1 Installation of external cover

1. Insert housing for external cover [10] in
wall breakthrough/wall sleeve.
2. Align housing horizontally and mark the
dowel holes.
3. Remove housing [10], drill M6 dowel holes
with a Ø of 6 mm and insert dowels.
4. Insert sensor connection cable [12]
through the opening on the external cover
in wall breakthrough/wall sleeve.
19