Hitachi E10U Handbuch Seite 11

● Engine switch
The engine switch controls the ignition and fuel systems to start or stop the
engine.
Operation of the engine switch is inter-locked with the operation of the fuel
cock and choke.
● AC output selection switch
The output of the generator can be decreased with a small load of connected
electric appliances to reduce noise and fuel cost.
● Oil sensor lamp
The lamp gives a warning for a low engine oil level.
When the engine oil level is reduced below the rated level, the oil sensor
lamp lights up and the engine is automatically stopped. If the engine oil is
below the rated level, the sensor lamp lights up and the engine does not
start even if the recoil starter handle is pulled.
NOTE: If the generator is inclined, the oil sensor functions to stop the
engine. Operate the engine on a level surface.
● Pilot lamp
After engine starts and electricity is generated, a green lamp lights up.
● AC outlet
AC outlet for electric appliances.
Two outlets are installed.
● DC terminal
DC terminal for charging a battery.
● Grounding terminal
Grounding terminal for prevention of electric shock.
Downloaded from www.Manualslib.com
Lever position for stopping the engine or for storage.
The gasoline does not flow.
Lever position for operating the engine. Place the switch in this
position when the engine is warm.
Lever position for starting the engine. The choke functions.
950VA For rated output 950VA
600VA To reduce the output to 600VA
manuals search engine
English
Engine switch
AC output selection switch
Fig. 12
Pilot lamp Oil sensor lamp
Fig. 13
AC outlet
~230V
TOTAL 4.1A
Fig. 14
DC terminal
12V 8.3A
Fig. 15
Grounding terminal
Fig. 16
11