Daily Use; The Heat Setting - AEG HK654070FB Benutzerinformation

8 www.aeg.com
3.4 OptiHeat Control (3 step
Residual heat indicator)

4. DAILY USE

4.1 Activating and
deactivating
Touch
deactivate the hob.
4.2 Automatic Switch Off
The function deactivates the hob
automatically if:
• all cooking zones are deactivated,
• you do not set the heat setting after
• you spill something or put something
• you do not deactivate a cooking zone
The relation between the heat setting
and the time after which the hob
deactivates:
Heat setting
4 - 7
8 - 9
10 - 14
Downloaded from www.Manualslib.com
WARNING!
/ / There is a risk of
burns from residual heat.
The indicator shows the level
of the residual heat.
WARNING!
Refer to Safety chapters.
for 1 second to activate or
you activate the hob,
on the control panel for more than 10
seconds (a pan, a cloth, etc.). An
acoustic signal sounds and the hob
deactivates. Remove the object or
clean the control panel.
or change the heat setting. After
some time comes on and the hob
deactivates.
The hob deacti-
vates after
6 hours
, 1 - 3
5 hours
4 hours
1.5 hour
manuals search engine

4.3 The heat setting

To set or change the heat setting:
Touch the control bar at the correct heat
setting or move your finger along the
control bar until you reach the correct
heat setting.
4.4 Activating and
deactivating the outer rings
You can adjust the surface you cook to
the dimension of the cookware.
Use sensor field:
To activate the outer ring: touch the
sensor field. The indicator comes on.
To activate more outer rings: touch the
same sensor field again. The subsequent
indicator comes on.
To deactivate the outer ring: touch the
sensor field until the indicator goes out.
When you activate the zone
but do not activate the outer
ring the light that comes out
from the zone may cover the
outer ring. It does not mean
that the outer ring is
activated. To see if the ring
is activated check the
indicator.