The »Inputs« Menu - Guntermann & Drunck RackConsole-PRO 17HR Installation Und Bedienung

The »Inputs« menu
In the menu, you can select the sources for the main picture channel and the
Inputs
PiP channel. In addition, you can use the menu to configure the PiP.
Imputs
DP

DVI-I

HDMI

DVI-I Modus
Auto

Digital

Analog

Autoscan
Off

On

DVI-A Autoadjust
On

Off

Select the signal source of the display.
The default setting is DisplayPort (DP).
Select whether the RackConsole should automatically (Auto) switch
between digital and analog DVI signals when no image is detected
for about 0.5 seconds.
You can also restrict the DVI operating mode to DVI-D (digital)
or DVI-A (analog).
When this function is activated, the RackConsole monitors all
signal inputs. The video signal of the first active input is shown on 
the display.
By default, the function is disabled.
You can disable the automatic calibration function of the analog
input. In this case the parameters of the last successful calibration
are used.
By default, the function is enabled.
On-screen display
RackConsole-PRO 17HR · 14