Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
- Buttons color
- Backlight
- Screen saver (Enabled, Disabled).
- Default screen
- Screen cleaner.
- Factory default user (interface).
6-
WIFI menu.
Reading button (refresh).
The Internet Access password allows you to link your central
unit to your Internet account (See below) for a remote control of
your system through the Internet or Smart Phone.
Note: At first use or software update, wait for some time until
the green State icon is active.
7-
Holidays menu.
- To set the departure/return dates and hours.
- Use < or > to select year/month/day, hour & minute.
- Set and validate the operating mode of the devices in holiday
mode. (Same menu as general commands menu).
8-
Installation menu (long press 3-4 s)
House creation
See house creation section.
A.
Radio pairing.
See radio pairing section.
B.
Delete a device:
Select device type and then the device.
C.
Delete all devices:
All devices installed in the system will be deleted (rooms
will be maintained).
.
D.
Identify a device
To identify a device of the installation
a- To put the menu in reception mode.
b- To access to the device parameters.
Process:
- Press on 'a' to make the Central active
- Press on the device receiver and wait a few seconds until
radio communication frame is transmitted.
Note: ID-number is displayed on the screen, please repeat to
be sure to have the same ID.
- Long press on
to change device parameters (name,
power ...).
E.
Screen Lock :
Enter your screen lock password, max 4 digits, and confim by
pressing the
buttom.Default rescue code "1066"
NOTE: If you do not define a code of your own in this menu, the
memory is empty and it is enough to press "green Check"
button to lock/unlock the screen!
Screen lock. Press on the icon and enter the default code
"1066" or enter the code you have configured here to lock the
screen.
F.
Heating settings:
You can fix setpoint limitations (min/max) per zone and the
offset assigned to devices working in floor sensor regulation.
G.
Heat & Cool settings:
Define the way how the heating and cooling are controlled
Only heating, only cooling or Heat & cool manual switch
H.
WIFI settings:
To set the WIFI configurations (SSID/Protected Access Key
Type/ Password). You can do it manually or scan the active
networks.
Configuration requesting a registration on a web page is not
supported.
WIFI Status:
0/2 : Central unit not connected to the wifi router and server
1/2 : Central unit connected to the Wifi router
2/2: Central unit connected to the wifi router and to the server
(Pairing of the central to an account is required)
Note: The connection to Internet is recommended with Certified
WiFi routers (http://www.wi-fi.org/certification).
Note: Automatic pairing time to WiFi router with WEP key: 3-4
min, with WPA2 key: 1 min.
Note: For the network scan, Repeat at least twice the operation
if your desired WiFi network is not displayed. If your desired
WiFi network is still not displayed, enter the WiFi settings
manually
I.
General factory default:
To reset the system with the factory values, but the software
version will remain the same.
4
Werbung
Inhaltsverzeichnis
