Main Characteristics; Installation - Purmo TempCo Touch E3 Montage- Und Bedienungsantleitung

MAIN CHARACTERISTICS

• Touch screen
• Interface via internet (WIFI)
• Wall mountable with power supply 85-265V (50-60)Hz
• Can be placed on the table with supplied bracket and mini
USB power supply (0-5V).
• Battery operation (only for settings)
• RF Communication with other devices
• Multiple heating/cooling devices control.
• SD Card update
• Intuitive menus for device management.
Charge the central unit for at least one hour before
pairing the devices already Installed
DEVICES compatible with TOUCH E3
Central unit
Connect
1M RF
Web, UP
Connect
1M RF X
Web, LC
Connect
1M RF
Web, Plug
Master 6Z
X
Web
Thermos-
tatic head X
web RF
Analoge
Web or
X
Digital
Web
Repeater
• 50 heating/cooling master devices (thermostats) and 50
heating/cooling slave devices (receivers).
• 25 ON/OFF devices with weekly program with 15 min steps.
• You may have to use a repeater if you want to extend the RF
range.
X X X X X X
X X X X X
X X X
X X X
X
X X X X X

INSTALLATION

a- Wall mounting
1- Connect the power as described below :
NOT TO BE USED
POWER SUPPLY 85-265V - 50/60HZ
2- Screw the power unit on the wall. Be careful! The tab must
be on the top !
3- Put the switch to ON position
ON/OFF
4- Mount the Central on the power unit and slide it on the
bottom to clip it. The Central is ready for operation.
b- Table installation
CABLE
ON/OFF
Connect the central unit with the cable (5V, 1A) and then mount
the leg support on it and put the switch to ON position. The
central unit is now ready for operation.
2