Installation - Neat PIR II Benutzerhandbuch

5 Regular movement detector
A common practice for a regular movement detector
is placing the detector under or beside a bed thus
alerting when a user gets out of bed at night (i.e.
used as a bed alarm).
5.1

Installation

Place the PIR II on the floor beside the bed or on a ta-
ble. Ensure that the unit is covering the best possible
area where the user will trig a movement alarm.
5.2 Configuration
Set the DIP-switches according to the table below.
DIP Setting
1
2
3
4
5
6
7
8
Table 3. DIP-settings for a regular movement detector.
PIR II User manual - NE41 19003-00 v1.2
OFF (Configuration with DIP-switches).
ON or OFF, see "13.2 DIP2 - Power save mode".
OFF (PIR II is used as a regular movement detector).
N/A
ON or OFF, see "13.5 DIP5 - IR detection sensitivity".
ON (Alarms are visually indicated).
ON (Movement detection is visually indicated).
ON or OFF, see "13.8 DIP8 - Disable OFF button (S5)/Alarm
delay".
11