Guntermann & Drunck RemoteAccess-GATE Installationsanleitung Seite 30

Initial configuration
3. Enter the following values under
Enable IPv6:
IP Auto
Configuration:
IP Address/
Prefix Length:
Default Gate-
way
Preferred
Hostname:
4. Enter the following values under
Speed:
Duplex:
5. Enter the following values under
DNS Resolver
Preference:
DNS Suffixes
(optional)
First/Second
DNS Server:
6. Click on Save .
8 · G&D RemoteAccess-GATE
Ethernet > IPv6
Enable or disable IPv6 protocol
Select the method by which the IPv6 settings are set:
 Static: Enter a static IP address.
 DHCP: Obtain IP address from a DHCP server.
Assign a static IPv6 address and specify the prefix length.
NOTE:
This setting is only available when using a static IP
address ( Static ).
Enter the IP address of the gateway.
NOTE:
This setting is only available when using a static IP
address ( Static ).
Enter a preferred hostname.
NOTE:
This setting is only available if the IP address is
obtained by a DHCP
Ethernet > Interface Settings
Select the speed of the LAN connection:
Auto , 10 MBit/s , 100 MBit/s
Select the duplex mode of the LAN connection.
Auto , Full or Half
Common Network Settings
Define which IP address is used when the DNS resolver
returns both Ipv4 and
If necessary, enter a DNS suffix.
Enter the IP address of the DNS server.
NOTE:
If DHCP or
without the definition of static DNS servers, the device uses the
DNS servers assigned by DHCP.
:
server.
or 1 Gbit/s
Ipv6 addresses.
Auto is selected for the IPv4/IPv6 settings
:
: