Changing The Admin Password; Configuring Network Settings - Guntermann & Drunck RemoteAccess-GATE Installationsanleitung

Changing the admin password

The first time you call up a client after you have set up the device, you will be
prompted to change the password.
NOTE: The default
Admin
How to change the admin password:
1. Start the desired client (see above).
2. Follow the instructions of the client to change the Admin password.

Configuring network settings

In the default setting of the device, the static IPv4 address
the network interface.
You can change the IP address and activate DHCP in the client under
Device Settings > Network
How to change the device network settings:
1. In the client, click on
2. Enter the following values under
Enable IPv4:
IP Auto
Configuration:
IP Address/
Prefix Length:
Default Gate-
way
Preferred
Hostname:
password is .
4658
.
Device Settings > Network
Ethernet > IPv4
Enable or disable IPv4 protocol
Select the method by which the IPv4 settings are set:
 Static: Enter a static IP address.
 DHCP: Obtain IP address from a DHCP server.
Assign a static IPv4 address and specify the prefix length.
The default IPv4 address is
NOTE: This setting is only available when using a static IP
address ( Static ).
Enter the IP address of the gateway.
NOTE: This setting is only available when using a static IP
address ( Static ).
Enter a preferred hostname.
NOTE:
This setting is only available if the IP address is
obtained by a DHCP server.
Initial configuration
192.168.0.1
.
:
.
192.168.0.1/24
G&D RemoteAccess-GATE · 7
is assigned to