Tempco Connect 1M RF Web Bedienungsanleitung Seite 2

CZ
GB
1. Presentation
Name Plug Receiver
Code Connect 1M RF Web, Plug
Relay Live contact
Applications Electrical Panel heater
Floor sensor NTC No
10kOhmas at 25°c
Multiple RX + RF Heating
thermostat
Multiple RX + Central ON/OFF
unit
Multiple RX + Central Heating
unit + RF thermostat
1.1 Plug receiver:
Status LED (RED/Green)
Green: Standby mode
Red: Heating demand (Output on)
OFF: Off mode
ON/OFF button
Short press: On/Off
RF Configuration button
Short press: Instantaneous RF transmission
5sec press: Thermostat or Central RF init.
15sec press: Reset of the receiver.
1.2 Flush receiver:
Output LED (Red)
Red: Heating demand
Blink: Floor sensor error
RF Configuration button
Short press: Instantaneous RF transmission
3sec press: Thermostat or Central RF init.
5sec press: Slave receiver init.
15sec press: Reset of the receiver.
Receivers
Flush receiver
Connect 1M RF Web,
UP
Live contact
Electrical panel heater
Electrical l floor heating
Hydraulic water floor
heating (1 actuator
output)
ON/OFF
Option
Heating
ON/OFF
Heating regulation based
on Floor sensor
Heating
2
Wall Receiver Wall Receiver Heat &
Cool
Connect 1M RF Web, Connect 1M RF Web,
LC FC
Live contact 2 x Free Contact
Electrical panel heater Boiler control
Hydraulic water floor Hydraulic water floor
heating (1 actuator heating and cooling (2
output) actuators outputs)
ON/OFF
No No
Heating Heating or cooling
ON/OFF ON/OFF
Heating Heating or cooling
RF LED (Green)
Fixed: RF configuration.
Flash: RF reception
OFF: Standby
Blink: RF Alarm
Red:
Blink: Timer 2H running
Timer 2H button
Short press: On/Off
(This function will not be fit back
to the Touch E3 thermostat)
Status LED (RED/Green)
Green:
Fixed: RF configuration
Flash: RF reception
OFF: Standby
Blink: RF Alarm
Red:
Fixed: Floor Limitation
Red/Green (Orange)
Fixed: Pilot wire information.