Viessmann 5039 Bedienungsanleitung Seite 4

2. Introduction
This LED model uses SMD LEDs to produce light matching
the lamp model. Low heat build-up and power input. Nearly
unlimited lifetime of the LEDs, so no more change is required.
3. Mounting
In order to mount the taxi sign into an existing model car, the car
has to be dismantled. For this reason mounting is only possible
in model cars which have not been glued together.
Most model cars can be dismantled by declamping and remov-
ing the ground plate. Some models require the bumpers to be
removed in order to be dismantled.
In any case you have to proceed with the utmost care
and, if in doubt, it is better to completely refrain from
mounting the sign.
- Drill a hole at the mounting site (Ø 2.2 mm).
- Insert the taxi sign with the connection cables from above
into the hole and fasten it from underneath with the retaining
ring (fig. 1).
- Now assemble the model car. Lead the connecting cables
through the wheel guards.
4. Connection
Caution:
Resistor and diode at the cables are needed for proper
function of the LED model. Never cut them off! Never cover
resistor or diode with insulation material, because they have
to be cooled by surrounding air!
While connecting the cables, leave a loop of about 2 – 3 cm
length below the LED model, so that you can pull and reverse
the LED model from the mounting hole during any work.
Connect the LED model to the lighting power output of a model
train transformer (e. g. item 5200) or power supply as shown
in fig. 2
5. Warranty
Each model is tested to its full functionality prior to delivery. The
warranty period is 2 years starting from the date of purchase.
Should a fault occur during this period please contact our
service department (service@viessmann-modell.com). Please
send the item to the Viessmann service department for check-
ing and repair only after consultation. If we find a material or
production fault to be the cause of the failure, the item will be
repaired free of charge or replaced. Expressively excluded from
any warranty claims and liability are damages of the item and
consequential damages due to inappropriate handling, disre-
garding the instructions of this manual, inappropriate use of the
model, unauthorized disassembling, construction modifications
and use of force, overheating and similar.
6. Technical data
Operating voltage:
Operating current:
Änderungen vorbehalten. Keine Haftung für Druckfehler und Irrtümer.
Die aktuelle Version der Anleitung finden Sie auf der Viessmann Homepage
unter der Artikelnummer.
Subject to change without prior notice. No liability for mistakes and printing
errors.
You will find the latest version of the manual on the Viessmann website using
the item number.
4
(with and without item 5215, power module)
Entsorgen Sie dieses Produkt nicht über den (unsortierten)
Hausmüll, sondern führen Sie es der Wiederverwertung zu.
Do not dispose of this product through (unsorted) domestic
waste, supply it to recycling instead.
Viessmann
Bahnhofstraße 2a
D - 35116 Hatzfeld-Reddighausen
info@viessmann-modell.com
+49 6452 9340-0
www.viessmann-modell.de
13 – 24 V digital signal
Modelltechnik GmbH
10 – 16 V AC ~
14 – 24 V DC =
ca. 10 mA
Made in Europe
98334
Stand 02/sw
01/2021
Ho/Kf