Specifications - Makita UH4261 Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Switch trigger B
1-2. Switch trigger A
1-3. Switch trigger C
4-1. Hook complete
4-2. Tool's cord
4-3. Extension cord
5-1. Holder
5-2. Cord

SPECIFICATIONS

• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbol
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
･
･
･
･
Intended use
The tool is intended for trimming hedges.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Downloaded from www.Manualslib.com
Explanation of general view
6-1. Holder
6-2. Arm cord hook band
10-1. Trimming direction
10-2. Tilt the blades
10-3. Hedge surface to be trimmed
11-1. String
15-1. Press
15-2. Chip receiver
Model
Blade length
-1
Strokes per minute (min )
Overall length
Net weight
Safety class
Read instruction manual.
DOUBLE INSULATION
Do not expose to rain.
Remove plug from the
immediately if the cable is damaged or
cut.
Only for EU countries
Do not dispose of electric equipment
together with household waste material!
In observance of European Directive
2002/96/EC on waste electric and
electronic equipment
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an environmentally
recycling facility.
manuals search engine
UH4261
420 mm
1,600
821 mm
2.9 kg
END220-4
Standard and can, therefore, also be used from sockets
without earth wire.
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 2.1 dB(A)
mains
Vibration
The vibration
determined according to EN60745:
Work mode : hedge trimming
Vibration emission (a
and its
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
compatible
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
ENE014-1
WARNING:
ENF002-1
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
4
15-3. Nut
15-4. Shear blade
16-1. Hooks
16-2. Fit the hooks into groove
16-3. Grooves
17-1. Press the hooks on both sides
17-2. Unlock the hooks
UH4861 UH5261
480 mm 520 mm
1,600 1,600
871 mm 921 mm
3.0 kg 3.0 kg
/II
) : 82 dB(A)
pA
) : 93 dB(A)
WA
Wear ear protection
total value (tri-axial vector
2
) : 6.7 m/s
h
2
ENG905-1
ENG900-1
sum)
ENG901-1