Connection To The Mains; Dmx-512 Connection / Connection Between Fixtures - Futurelight MH-640 Bedienungsanleitung

Connection to the mains

Connect the fixture to the mains with the power-plug.
The occupation of the connection-cables is as follows:
Cable
Brown
Blue
Yellow/Green
The earth has to be connected!

DMX-512 connection / connection between fixtures

Only use a stereo shielded cable and 3-pin XLR-plugs and connectors in order to connect the controller with
the fixture or one fixture with another.
Occupation of the XLR-connection:
If you are using the recommended FUTURELIGHT-controllers, you can connect the DMX-output of the
controller directly with the DMX-input of the first fixture in the DMX-chain. If you wish to connect DMX-
controllers with other XLR-outputs, you need to use adapter-cables.
Building a serial DMX-chain:
Connect the DMX-output of the first fixture in the DMX-chain with the DMX-input of the next fixture. Always
connect one output with the input of the next fixture until all fixtures are connected.
Caution: At the last fixture, the DMX-cable has to be terminated with a terminator. Solder a 120
between Signal (–) and Signal (+) into a 3-pin XLR-plug and plug it in the DMX-output of the last fixture.
Downloaded from www.Manualslib.com
Pin International
Live L
Neutral N
Earth
The wires must not come into contact with each other, otherwise
the fixtures will not work at all, or will not work properly.
manuals search engine
30
Ω
resistor