Installation; Fitting/Exchanging The Lamp - Futurelight MH-640 Bedienungsanleitung

Fitting/Exchanging the lamp

lamp manufacturer's notes!
Do not touch the glass-bulb bare-handed during the installation! Make sure that the lamp is installed tightly
into the lampholder system.
Reinsert the lamp assemlby and tighten the 2 screws again.
Before striking the lamp, reset the "LAti" counter in the main menu of the Control Board, by pressing the
"Up" and "Down" buttons in one time and then confirming with the Enter-button.
Lamp adjustment
Screws "A, B, C"
Downloaded from www.Manualslib.com
Install the lamp with the device switched off only.
Unplug from mains before!
Lamp assembly
2 Phillips screws
Do not operate the fixture with opened housing-cover!
The MH-640 lampholder is aligned at the factory. Due to differences between
lamps, fine adjustment may improve light performance.
Strike the lamp and focus the light on a flat surface (wall). Center the hot-spot
(the brightest part of the beam) using the 3 adjustment screws „A, B, C". Turn
one screw at a time to drag the hot-spot diagonally across the projected
image. If you cannot detect a hot-spot, adjust the lamp until the light is even.
To reduce a hot-spot, pull the lamp in by turning all three screws „A, B, C"
clockwise ¼-turn at a time until the light is evenly distributed.
If the light is brighter around the edge than it is in the center, or if light output
is low, the lamp is too far back in the reflector. „Push" the lamp out by turning
the screws „A, B, C" counterclockwise ¼-turn at a time the light is bright and
evenly distributed.
manuals search engine

Installation

DANGER!
To insert the lamp MSD 230V/250W or
MSD 230V/200W open the small cover at
the rear of head (see the drawings) by
loosening the 2 Phillips screws on the
cover.
Gently pull out the lamp assemby.
If changing the lamp, remove the old lamp
from the socket. Insert the lamp to the
socket.
Do not install a lamp with a higher
wattage!
temperatures the device is not designed
for.
Damages caused by non-observance are
not subject to warranty. Please follow the
28
A lamp like this generates