Led Code Chart - Intex PureSpa SB-H20 Benutzerhandbuch

LED Reading
E90
E94 Water temperature too low
E95
Water temperature too high
E96
E97 Dry-fire Protection
E99 Water temperature sensor broken • Contact Intex Service Center.
After 72 hours of continuous
heating operation, the pump will
END hibernate automatically. The rapid
heating and water filtration
functions are disabled.
S AVE THESE INSTRUCTIONS
(347IO) SPA ENGLISH 7.5" X 10.3" PANTONE 295U 07/08/2020

LED CODE CHART

CAuSE
• Turn off and unplug the control unit.
• Ensure the outlet cover grid is clean and free
from obstructions.
• Clean or replace the cartridge, see
Maintenance and Storage section.
No water flow • Ensure the in/outlet connections on the spa tub
and filter pump are not blocked.
• Keep the spa water properly sanitized to
ensure a clean and unclogged filter cartridge.
• If problem persists, contact Intex Service
Center.
• If the ambient temperature is below 4°C (39°F),
we recommend not to use the spa.
• Turn off and unplug the control unit, add some
warm water to raise the spa water temperature
above 5°C (41°F), then press the
heat up the water to the desired temperature.
• If problem persists, contact Intex Service
center.
• Turn off and unplug the control unit. When the
water has cooled down, plug the RCD and
restart all over again.
• Turn the heater off, then press the filter and
bubble buttons to lower the water temperature.
• If problem persists, contact Intex Service
Center.
• Turn off and unplug the control unit. Plug the
RCD and restart all over again.
System Error
• If problem persists, contact Intex Service
Center.
• Contact Intex Service Center.
• Press the
filter pump.
English
SOLuTION
button to
button to re-active the
Page 16
347
A