Operation; Celsius/Fahrenheit Toggle Button - Intex PureSpa SB-H20 Benutzerhandbuch

SPA CONTROL uNIT PANEL
F
G
E
D
On/Off Button:
buttons. The light next to the button is green when activated. Press this button to turn off all
currently activated functions.
NOTE: The On/Off button may appear as a black button in the center of the control panel.
Heat Button:
until the water temperature reaches the set temperature. When the spa water temperature drops
1-2°C (1.8-3.6°F) below the set temperature the heating system will restart. When the flame icon
on the display is red, the heating system is activated. When the flame icon turns green, the
water is at the set temperature. The heating system is at rest and the filtration system will
continue working nonstop.
NOTE: To stop the filtration system while the heater is at rest mode, press the flame button first
and then the filter button. Pressing the flame button only while the heater is at rest mode will
turn off the heating system only and the filtration system will operate for another 24 hours before
it turns off automatically.
IMPORTANT: The following conditions will lead to slow water heating.
• The ambient temperature is lower than 10ºC (50ºF).
• Outdoor wind speed is above 3.5-5.4 m/s (8-12 mph).
• The air bubble function is activated when heating the spa water.
• The spa is not properly covered with the spa cover when the water is heating.

Celsius/Fahrenheit Toggle button:

The temperature can be displayed in either Fahrenheit or Celsius. The system's default is
Celsius.
NOTE: The default temperature is 20°C (68°F). Temperature adjustment ranges from 20°C (68°F)
to 40°C (104°F).
Temperature Adjustment Buttons:
buttons will cause the LED to flash. When flashing you can adjust to the desired temperature
setting. If you hold these buttons down the values will rapidly increase or decrease. The new
and desired temperature setting will remain on the LED display for 5 seconds to confirm the new
value.
Water Filter Button:
This button turns the filter pump on and off. If the heating system is activated the filtration
system will automatically start.
The water filter icon on the display is green when activated.
Bubble Button:
auto-shutoff feature. The bubble icon on the displays is green when activated.
CAuTION: Do not run Bubble system when the cover is attached, air can accumulate
inside the spa and cause irreparable damage and bodily harm.
40
o C
LED Display:
NOTE: the built-in hard water treatment function works automatically in conjunction with the filtration system.
NEVER use the spa if indicated water temperature is more than 40°C (104ºF).
S AVE THESE INSTRUCTIONS

OPERATION

Once the unit is plugged in, use this button to active the control unit panel
Use this button to activate the heating system. The pump will heat the spa water
Pressing the Temperature Increase or Decrease
Use this button to activate the massage system, which has a 30-minute
Once plugged in the LED displays the current water temperature automatically.
WARNING
(347IO) SPA ENGLISH 7.5" X 10.3" PANTONE 295U 07/08/2020
A: Heat Button
A
B: Celsius/Fahrenheit Toggle Button
C: Temperature Increase Button
B
D: Temperature Decrease Button
H
E: Water Filter Button
F: Bubble Button
C
G: LED Display
H: On/Off Button
347
English
A
Page 15