Storage - Intex PureSpa SB-H20 Benutzerhandbuch

MAINTENANCE (continued)
Spa Surround
Barefoot areas and relaxing areas around the spa shall be cleaned on a regular basis. No cleaning water may
flow into the spa or spa water cycle. The dirt and cleaning agents shall be rinsed carefully to drain in the spa
surround.
Spa Tub and Cover Air Bladder Repair
Use the enclosed repair patch to repair any puncture:
• Clean and dry the area to be repaired thoroughly.
• Remove the patch backing paper and press patch firmly over the puncture. Smooth out the surface to
remove any air bubbles under the patch.
In regions subject to freezing temperatures, drain, clean, disassemble and properly store the spa set and related
components indoors when the temperature drops below 4°C (39°F).
1. Drain and clean the spa following the "Spa Tub Drainage" and "Spa Tub Cleaning" sections.
2. Reverse set up instructions to deflate and disassemble the spa tub, spa control unit and spa cover air
bladder.
3. To deflate the tub and the cover air bladder:
a) Open the deflation outlet cap (27) with the included bolt
wrench (6) (see drawing 18).
b) Insert deflation hose adaptor (28) into the deflation outlet.
c) Insert inflation hose (7) over the deflation hose adaptor (28).
d) Insert the other end of the inflation hose into the tub air valve
or cover air bladder valve.
e) Press the air bubble
f) When deflation is completed reverse above steps and
ensures the deflation outlet cap (27) is securely fastened.
Caution: Only use for the purpose described in this manual.
Keep the inflation hose away from water or small objects when the
deflation function is activated to avoid damage to the blower motor.
4. Make sure all the spa components and accessories are thoroughly
clean and dry before storage. Air-dry the spa tub in the sun for an
hour before folding.
5.
Fold the spa tub loosely and avoid any sharp corners to prevent
damage or leakage to the spa tub liner.
6.
Prepare additional new cartridges for next time use.
7. Store the spa tub and accessories indoors, in a dry, temperature controlled, between 0º – 40ºC
(32º – 104ºF), storage location.
8. The original packing can be used for storage.
S AVE THESE INSTRUCTIONS

STORAgE

button to deflate.
(347IO) SPA ENGLISH 7.5" X 10.3" PANTONE 295U 07/08/2020
27
6
28
347
English
A
18
1
2
3
7
Page 22