Continuous Mode; Regulate Shaking Movement Intensity - Heidolph Hei-MIX Reax top Betriebsanleitung

Operation
➜ Place the test tube in the test tube tray and hold it firmly with a slight downward
pressure.
– The shaking movement starts by applying pressure with the test tube.
➜ As soon as the test tube is removed from the test tube tray, the shaking movement
will stop.

Continuous mode

Switching between automatic and continuous mode is done via the slide switch of the
device, see also "Device overview" on page 30.
➜ Move the slide switch to the left into the CONTINUOUS MODE position, see
figure. The continuous mode icon must be visible:
➜ The shaking movement starts as soon as the slide switch is in the CONTINUOUS
MODE position!
➜ Move the slide switch to the right into the AUTOMATIC MODE position or
SWITCH OFF the device to stop the movement.

Regulate shaking movement intensity

The shaking movement intensity is set by the speed and by means of the speed
controller of the device.
WARNING
Risk of splashing!
If shaking movement starts too quickly, fluid may splash out of the
test tube.
➜
➜
WARNING
Possible overload of hand and arm!
Depending on the effort and duration, holding the sample in auto-
matic mode can lead to overloads in the hand and arm area.
➜
Use recommended personal protective equipment (e.g. safety
glasses, protective clothing).
Set the speed controller to zero before switching on the device.
Gradually increase the speed to the desired value as the
shaking movement starts.
When using the device, observe the specifications of the EC
directive 2002-44 on the permissible vibration load.
33