Shaking Modes; Automatic Mode - Heidolph Hei-MIX Reax top Betriebsanleitung

Shaking modes

The device can be used in automatic or continuous mode:
– In automatic mode, shaking begins as soon as a suitable test tube is pressed
into the test tube tray.
– In continuous mode, the movement starts without applying pressure on the test
tube tray. The shaking movement must be stopped manually!
WARNING
Risk of injury!
In continuous mode, the device automatically restarts after an
interruption (e.g. fuse tripping, power failure). There is a risk of
injury in the area of movement of the device!
➜
CAUTION
Risk of slipping! Risk of falling! Risk of tipping!
Depending on the load and configuration, depending on the speed,
there is a risk of excessive vibration of the device during operation.
There is a risk that the device moves uncontrollably, falls or tips
over.
➜
➜
➜

Automatic mode

Switching between automatic and continuous mode is done via the slide switch of the
device, see also "Device overview" on page 30.
➜ Move the slide switch to the right into the AUTOMATIC MODE position, see
figure. The automatic mode icon must be visible:
In the event of a power failure, switch off the device and keep
sufficient distance!
Observe the instructions for the correct positioning of the
device!
Set the speed controller to zero before switching on the device.
Gradually increase the speed to the desired value as the
shaking movement starts. Observe the device for sufficient
stability.
Check and correct the configuration if excessive vibrations are
detected!
32
Operation